Convert DT_.*_GPIO_{CONTROLLER,PIN,FLAGS} ->
DT_.*_GPIOS_{CONTROLLER,PIN,FLAGS)
Used the following commands to make these conversions:
git grep -l DT_.*_GPIO_CONTROLLER | xargs sed -i 's/DT_\(.*\)_GPIO_CONTROLLER/DT_\1_GPIOS_CONTROLLER/g'
git grep -l DT_.*_GPIO_PIN | xargs sed -i 's/DT_\(.*\)_GPIO_PIN/DT_\1_GPIOS_PIN/g'
git grep -l DT_.*_GPIO_FLAGS | xargs sed -i 's/DT_\(.*\)_GPIO_FLAGS/DT_\1_GPIOS_FLAGS/g'
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Most of the basic tests trigger LEDs or expect button press and would
hang in device testing because we can't parse success or failure from
the console. Define harness for this with the intent to skip those in
sanitycheck device testing and until we have a better way to test those.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Some boards' configuration does not enable GPIO by default,
like nrf52_pca10056, it causes ASSERTION FAIL when running
this application. This fix is to enable GPIO by default for
the basic threads sample, like basic blinky sample does.
Signed-off-by: Aaron Tsui <aaron.tsui@outlook.com>
Update the filters that are extracting info from DT to use a define that
has a DT_ prefix so its clear that its coming from DT_. Also this lets
us remove any non-DT prefixed defines in the conf db.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Do not limit to whitelisted boards, instead make it build/run for any
board that defines required DTS macros.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Remove redundant 'sample' tag and add something that matches the
functionality and features being tested, demonstrated.
Avoid short abbriviations and using full names for fs.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Remove build_only and add harness type needed for the sample/test to
allow running with sanitycheck and on devices once we have harness
support.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Kumar Gala