Allow user to configure a program that is executed after the
network interface is created and IP address is setup.
This can be used e.g., to start wireshark to capture
the network traffic of the interface.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
- Remove redundant 'n' defaults. 'n' is the default value for bool
symbols.
This makes the auto-generated documentation clearer as well: You get
"implicitly defaults to n" instead of
"- n if <propagated dependencies>".
- Shorten
<type>
prompt "foo"
to
<type> "foo"
This works for all types, not just bool.
- Various formatting nits.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Allow gPTP code to be run as a linux process and communicate
with gPTP daemon running in linux host.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Bool symbols implicitly default to 'n'.
A 'default n' can make sense e.g. in a Kconfig.defconfig file, if you
want to override a 'default y' on the base definition of the symbol. It
isn't used like that on any of these symbols though, and is
inconsistent.
This will make the auto-generated Kconfig documentation have "No
defaults. Implicitly defaults to n." as well, which is clearer than
'default n if ...'
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
As the native_posix board has ethernet driver, then enable it by
default if networking is enabled in prj.conf file. This way we can
use generic networking config file when running the application
for native_posix board.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
This creates zeth network interface in your host and allows user
to send and receive data sent to this network interface.
Fixes#6007
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Jukka Rissanen