Use devicetree instead of Kconfig to configure the board control
switches in nRF9160 DK:
- add binding for the switches that provide optional signal routings
on this board
- add binding for the GPIO interface that can be used for communication
(e.g. UART based) between the nRF9160 and the nRF52840 on the DK,
and add GPIO mapping for this interface so that its lines can be used
without caring about of actual pin numbers on both sides
- add binding for one GPIO line chosen from the above interface that is
to allow the nRF9160 to reset the nRF52840
- update accordingly dts files and board specific code for both board
definitions associated with the DK
- introduce .dtsi files that can be included from dts overlays in order
to facilitate the use of the above GPIO interface; modify the overlay
in the hci_uart sample to provide an example of use of those files
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
IEEE 802.15.4 is available for each board with Nordic SOC implementing
this protocol. Because of that protocol configuration shall be tied to
SOC instead of board.
Signed-off-by: Hubert Miś <hubert.mis@nordicsemi.no>
We rename the nRF91 Dev Kit board target for the NRF52840
controller (nrf52840_pca10090) to nrf9160dk_nrf52840. We
update all associated references in the supportive
documentation and all nRF9160-related cofigurations and
overlay files in the samples and tests in the tree. We
also remove an un-referenced board image file that had
erroneously been part of the documentation of this platform.
Signed-off-by: Ioannis Glaropoulos <Ioannis.Glaropoulos@nordicsemi.no>
Andrzej Głąbek