On LSM6DSO sensor the INT1 pin is used for both generating the drdy
interrupt and for switching to I3C hotjoin mode just after reset if
it is at logical '1' level. If you reset the x_nucleo_shield3 board
the LSM6DSO enter in hot join, as INT1 '1' level is preserved by
the level shifter.
This commit switch to INT2 to generate DRDY interrupt, so that INT1
always remain to logical '0' level.
Fixes: #20933
Signed-off-by: Armando Visconti <armando.visconti@st.com>
Configure interrupt gpio information (irq-gpios) into the
x-nucleo-iks01a3 shield overlay file.
Signed-off-by: Armando Visconti <armando.visconti@st.com>
stm32mp157c_dk2 Arduino header lack A2 and A3 pins which
are assigned to non GPIO pins.
Remove optional shields properties that are using one of these
pins by providing board overlays to the impacted shields.
Fixes#19079
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
The LIS2MDL is not a combo device, but pure magnotemeter.
Hence, '-magn' extension is not adding information and can
be removed from dts compatible name as well as binding filename.
Instead specify '-i2c' or '-spi' to distinguish between the names.
Signed-off-by: Armando Visconti <armando.visconti@st.com>
x-nucleo-iks01a3 shield is an arduino compatible companion board
which can be used on top of Nucleo standard boards. It extend
the Nucleo functionalities adding following MEMS sensor support:
- LSM6DSO accel and gyro
- LIS2MDL magnetometer
- LIS2DW12 accel
- LPS22HH pressure
- HTS221 humidity
Signed-off-by: Armando Visconti <armando.visconti@st.com>
Kumar Gala