STM32 uart Kconfig instance flags were not following
same naming scheme than other drivers (i2c, spi, ..)
Update driver to use UART_X instead of UART_STM32_PORT_X
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Update stm32f723e_disco configuration to match with
default configuration guidelines:
-Configure available connectors
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Enable the support for the 3 I2C buses of the STM32F723E-DISCO board,
connected respectively to the WM8994, the Arduino V3/STMOD+ and the
touch panel.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
This patch adds basic support and documentation for the STM32F723E-DISCO
board, with GPIO, USART, I2C and USB support. Two USARTs are enabled,
the VCP one for the console and the Arduino one. The GPIOs are
configured for the 3 LEDs and the button available on the board.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Erwan Gouriou