Use this short header style in all Kconfig files:
# <description>
# <copyright>
# <license>
...
Also change all <description>s from
# Kconfig[.extension] - Foo-related options
to just
# Foo-related options
It's clear enough that it's about Kconfig.
The <description> cleanup was done with this command, along with some
manual cleanup (big letter at the start, etc.)
git ls-files '*Kconfig*' | \
xargs sed -i -E '1 s/#\s*Kconfig[\w.-]*\s*-\s*/# /'
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Now that all supported xtensa boards use DTS we can move the Kconfig
setting to the arch level. Remove HAS_DTS from board Kconfig files.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Unconditionally use CONFIG_SIMULATOR_XTENSA to determine if XT_SIMULATOR
or XT_BOARD should be defined.
If CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC, also define XT_CLOCK_FREQ. This
isn't ideal as the clock frequency might be changed in runtime and this
effectively makes it a constant.
Until we can control the clock frequency in runtime, this will suffice.
Signed-off-by: Leandro Pereira <leandro.pereira@intel.com>
This is a minimal driver enabling console output during the port
bringup. While the driver works, only one of the three UART devices
are supported, and there isn't any way to change any parameters or
use interrupts. This will most likely be superceded by a proper
driver after the port has matured.
Signed-off-by: Leandro Pereira <leandro.pereira@intel.com>
Ulf Magnusson