The Arduino 101 comes with a bootloader that supports DFU
and flashing of all cores using the dfu-util package.
This changes the memory layout of the image built for the
Arduino 101 and remove previous work-arounds to allow booting,
including the version-header section in the linker script.
The bootloader expects the text section at +0x30 from the physical
load address and thus requires special treatment in the linker
script.
Other changes by Andrew Boie:
The flash size parameters were both wrong. X86 side has 192K
of flash from 0x4003000 - 0x40060000, the entire span of
sys_flash1.
ARC side is now the span from 0x40010000 - 0x40030000, 128K.
Change-Id: Iecfa5d2b84a3f522d9eca06268d6b8b71a094aaa
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
CONFIG_UART_NS16550_ACCESS_MMIO doesn't exist anywhere so remove it from
the defconfig.
Change-Id: I221cbb4a9fe5c4ee567e994f2c617b50b1228d13
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
I see in the TOP makefile that if FLASH_SCRIPT is undefined,
it outputs the message "Flashing not supported with this board".
This behavior is wanted currently as this board does not
have a memory mapped FLASH device. It has a SPI-FLASH and
there are different instructions for putting an image on to the board.
Change-Id: I07dcdd9a7fd8346b846ee0fe1312d22f9ffaa13e
Signed-off-by: Chuck Jordan <cjordan@synopsys.com>
Convert leading whitespace into tabs in Kconfig files. Also replaced
double spaces between config and <prompt>.
Change-Id: I341c718ecf4143529b477c239bbde88e18f37062
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Board support for the ARC EM Starter Kit provides for a board
that can select one of two SOCs. The EM9D and EM11D commits
will be done separately to expidite review. Also submitted here
is doc/board/em_starterkit.rst to explain details about this
Zephyr board choice.
Change-Id: Icd9fac045c700ad8dcb95161fdd63c130f665778
Signed-off-by: Chuck Jordan <cjordan@synopsys.com>
Anas Nashif