By changing the various *NET_DEVICE* macros. It is up to the device
drivers to either set a proper PM function or, if not supported or PM
disabled, to use device_pm_control_nop relevantly.
All existing macro calls are updated. Since no PM support was added so
far, device_pm_control_nop is used as the default everywhere.
Signed-off-by: Tomasz Bursztyka <tomasz.bursztyka@linux.intel.com>
Convert couple of MSEC() calls to K_MSEC() as the timeouts
when using MSEC() are just too long.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
We had a typo in the Kconfig symbol that was being used to try and set
SYS_LOG_LEVEL. It should be CONFIG_SYS_LOG_NET_LOOPBACK_LEVEL.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
If we could not send the packet, then do not release the net_pkt
as that will be released in net_if.c:net_if_tx() if driver send()
fails.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Instead of passing net_pkt as is to the receiving side of the
interface, clone the sent packet and drop the sent one.
This is needed mainly in TCP where passing the same packet from
sending to receiving side is causing havoc.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Loopback is a networking interface which doesn't actually transfer
any data via link layer externally, and instead just mirrors back
(i.e. any packet send to the loopback interface will be received from
it). This interface very useful for testing.
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
Tomasz Bursztyka