Add SPI support for stm32mp157c_dk2 board. If SPI is selected, SPI4
(Arduino connector compatible SPI) and SPI5 (on front 2x20 GPIO
expander) will be enable by default on stm32mp157c_dk2 board.
Signed-off-by: Yaël Boutreux <yael.boutreux@st.com>
Signed-off-by: Arnaud Pouliquen <arnaud.pouliquen@st.com>
Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>
This board and SoC was discontinued some time ago and is currently not
maintained in the zephyr tree.
Remove all associated configurations and variants from the tree.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Add the Atmel SAM R21 Xplained Pro Evaluation Kit to zephyr.
So far, UART, SPI, I2C (depends on #14128), debug LED and user button
have been tested.
Signed-off-by: Benjamin Valentin <benpicco@googlemail.com>
The options selecting nRF drivers are now enabled by default when
an nRF SoC is selected as the build target.
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
This change adds DTS definition of SPI device for nRF chips.
It also removes SPI pin configuration from Kconfig and moves it to
chip DTS.
Signed-off-by: Filip Kubicz <filip.kubicz@nordicsemi.no>
During the spi rework we removed the qmsi spi drivers so we no longer
have Kconfig symbols or drivers related to CONFIG_SPI_QMSI{_SS}. There
are a few references still around that we should remove
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
This adds a translation layer to make the nrfx driver for the nRF SPIM
(SPI Master with EasyDMA) peripheral accessible via the Zephyr's API.
The shim is provided only for nRF52840 because of a hardware anomaly
present in nRF52832. See Anomaly 58 (SPIM: An additional byte is clocked
out when RXD.MAXCNT = 1) in Errata for this chip.
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
This adds to the spi_loopback test board-specific configurations
for the following boards:
- nrf51_pca10028
- nrf52_pca10040
- nrf52840_pca10056
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
The SAM0 SoC was switched to use DTS for SPI configuration. Adapt the
spi_loopback test configuration for the Arduino Zero to use the
correct device name.
Signed-off-by: Henrik Brix Andersen <henrik@brixandersen.dk>
This restores the board specific configurations that were present
before moving the test to using KConfig.
<board>.conf files from boards subdirectory get merged with
prj_base.conf file.
Signed-off-by: Daniel Wagenknecht <wagenknecht.daniel@gmail.com>
Yaël Boutreux