This enables the ACPI_EC1 interface which is typically accessed
through ports 0x6A0 and 0x6A4 in Bios.
Signed-off-by: Rajavardhan Gundi <rajavardhan.gundi@intel.com>
Enable ESPI OOB channel by default in XEC driver.
Enable OOB channel transmit interrupt and handle OOB up/down correctly.
Change interrupt clearing, clear low level interrupt bits in subhandlers
and high level interrupt in aggregate handlers at the end.
Signed-off-by: Jose Alberto Meza <jose.a.meza.arellano@intel.com>
Use this short header style in all Kconfig files:
# <description>
# <copyright>
# <license>
...
Also change all <description>s from
# Kconfig[.extension] - Foo-related options
to just
# Foo-related options
It's clear enough that it's about Kconfig.
The <description> cleanup was done with this command, along with some
manual cleanup (big letter at the start, etc.)
git ls-files '*Kconfig*' | \
xargs sed -i -E '1 s/#\s*Kconfig[\w.-]*\s*-\s*/# /'
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Defining a symbol with 'menuconfig' just tells the menuconfig to display
any dependent symbols that immediately follow it in a separate menu.
'menuconfig' has no effect on symbol values.
Making a symbol that doesn't have any dependent symbols after it a
'menuconfig' should be avoided, because then you end up with an empty
menu, which is shown as e.g.
[*] Enable foo ---
This is how it would be shown if there were children but they all
happened to be invisible as well.
With a regular 'config', it turns into
[*] Enable foo
Change all pointless 'menuconfig's to 'config's.
See the section on 'menuconfig' on the Kconfig - Tips and Best Practices
page as well.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
When a eSPI slave needs to send back-to-back packets
updating status signal need to guarantee both status
reach the eSPI host, i.e. SCI=0 followed by SCI=1.
This change guarantees both packets are transmitted
over esSPI bus.
Allow to map eSPI host logical UART to a soc UART.
Signed-off-by: Jose Alberto Meza <jose.a.meza.arellano@intel.com>
The ESPI_PERIPHERAL_* symbols are surrounded by an
'if ESPI_PERIPHERAL_CHANNEL' in the same file, so no
need to put 'depends on ESPI_PERIPHERAL' on them.
'if' is just a shorthand for 'depends on'.
Also remove a redundant 'if ESPI' from ESPI_XEC.
drivers/espi/Kconfig.xec is sourced within an 'if ESPI' in
drivers/espi/Kconfig.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Add eSPI Microchip XEC driver
Include support for peripheral & virtual wires (channel 0-1)
OOB and flash support can be added in the future
Fix compilation error in pinmux driver
Signed-off-by: Jose Alberto Meza <jose.a.meza.arellano@intel.com>
Rajavardhan Gundi