Increases 2 variables to be 16-bits instead of 8-bits to allow
for target read sizes, this would only be an issue if someone
changed the default retention block size from the default value
of 16 to a value over 256
Signed-off-by: Jamie McCrae <jamie.mccrae@nordicsemi.no>
Fixes an issue which would cause a fault if someone attempted
to write to the (non-writable) blinfo keys
Signed-off-by: Jamie McCrae <jamie.mccrae@nordicsemi.no>
Adds a bootloader configuration interface which allows for a
bootloader (e.g. MCUboot) to set configuration in a shared data
area which is then read by the application.
Signed-off-by: Jamie McCrae <jamie.mccrae@nordicsemi.no>
Will exclude the code for prefix and checksum functionality if none
of the entries on a device make use of these features, saves ~816
bytes when both features are excluded.
Signed-off-by: Jamie McCrae <jamie.mccrae@nordicsemi.no>
Changes the Kconfig option to allow disabling mutex support, this
is to allow other Kconfig options to disable the feature.
Signed-off-by: Jamie McCrae <jamie.mccrae@nordicsemi.no>
Adds a command which can be used to enter mcuboot's serial recovery
mode when the retention subsystem is enabled.
Signed-off-by: Jamie McCrae <jamie.mccrae@nordicsemi.no>
Adds a boot mode system which allows for redirecting the boot
target of a device depending upon the state of a retained value.
Signed-off-by: Jamie McCrae <jamie.mccrae@nordicsemi.no>
Adds a retention system which builds on top of retained_mem
drivers to allow partitioning of areas and data integrity with
magic header prefixes and checksum of stored data.
Signed-off-by: Jamie McCrae <jamie.mccrae@nordicsemi.no>
Jamie McCrae