During the spi rework we removed the qmsi spi drivers so we no longer
have Kconfig symbols or drivers related to CONFIG_SPI_QMSI{_SS}. There
are a few references still around that we should remove
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
This adds a translation layer to make the nrfx driver for the nRF SPIM
(SPI Master with EasyDMA) peripheral accessible via the Zephyr's API.
The shim is provided only for nRF52840 because of a hardware anomaly
present in nRF52832. See Anomaly 58 (SPIM: An additional byte is clocked
out when RXD.MAXCNT = 1) in Errata for this chip.
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
This adds to the spi_loopback test board-specific configurations
for the following boards:
- nrf51_pca10028
- nrf52_pca10040
- nrf52840_pca10056
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
The SAM0 SoC was switched to use DTS for SPI configuration. Adapt the
spi_loopback test configuration for the Arduino Zero to use the
correct device name.
Signed-off-by: Henrik Brix Andersen <henrik@brixandersen.dk>
This restores the board specific configurations that were present
before moving the test to using KConfig.
<board>.conf files from boards subdirectory get merged with
prj_base.conf file.
Signed-off-by: Daniel Wagenknecht <wagenknecht.daniel@gmail.com>
Kumar Gala