Standard Arduino CLK signal is on D13,
nucleo_l476rg board has been modified accordingly.
Need an overlay to use default x_nucleo_idb05a1 spin D3 (PB3)
Signed-off-by: Alexandre Bourdiol <alexandre.bourdiol@st.com>
This shield is working out of the box on Arduino connector,
even if it is not with all standard Arduino SPI CS/CLK pins.
Signed-off-by: Alexandre Bourdiol <alexandre.bourdiol@st.com>
Update bluetooth hcp spi driver to new GPIO API.
Following changes have been done:
- Use new gpio api functions
- Get reset, irq and cs flags from dt defines
- Define reset pin as active low and invert set/unset logic.
Tested on disco_l475_iot1 and 96b_carbon.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Put shield configuration Kconfig flags in new Kconfig.defconfig.
This way shield BLE susbystem can now be selected by application
using BT symbol, similarly to what is done when BlueNRG ship is
directly present on board.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Add configuration file for the stm32mp157c_dk2.
Beacon, Central are working.
Peripheral is not compiling because of .elf exceeding FLASH region,
else should be working.
Signed-off-by: Yaël Boutreux <yael.boutreux@st.com>
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Add shield x_nucleo_idb05a1.
Tested samples with the disco_l475_iot1 (SPI3 disabled to ensure
to test the shield on SPI1, and not the on-board BlueNRG-MS chip):
Beacon, Central and Peripheral have been tested and are working.
Signed-off-by: Yaël Boutreux <yael.boutreux@st.com>
Signed-off-by: Erwan Gouriou <erwang.gouriou@linaro.org>
Nazar Kazakov