Pinmux driver almost certainly should be initialized before the
rest of hardware devices (which may need specific pins already
configured for them), and usually after generic GPIO drivers.
Thus, its priority should be between KERNEL_INIT_PRIORITY_DEFAULT
(default 40) and KERNEL_INIT_PRIORITY_DEVICE (default 50). Thus,
we set PINMUX_INIT_PRIORITY to 45.
There are exceptions to the rule above for particular boards. For
example, BOARD=galileo has GPIO and pinmuxer on I2C bus and thus
overrides PINMUX_INIT_PRIORITY to be much higher. Note that while
PINMUX_INIT_PRIORITY was defined previously (at 60), it was used
only for galileo, which overrides it anyway.
This fix was prompted by investigation why eth_ksdk driver was
non-functional after kernel priorities re-hashing: both eth_ksdk
and pinmux used the same priority, and eth_ksdk happened to run
before pinmux. While bumping eth_ksdk priority would help in the
particular case, the same would likely reoccur with other drivers
like I2C, SPI, etc.
Change-Id: Ie5ca3135c1ee2fe8d9cf48d5c12e62eac63487f7
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
PRIMARY, SECONDARY, NANOKERNEL, MICROKERNEL init levels are now
deprecated.
New init levels introduced: PRE_KERNEL_1, PRE_KERNEL_2, POST_KERNEL
to replace them.
Most existing code has instances of PRIMARY replaced with PRE_KERNEL_1,
SECONDARY with POST_KERNEL as SECONDARY has had a longstanding bug
where the documentation specified SECONDARY ran before the kernel started
up, but actually ran afterwards.
Change-Id: I771bc634e9caf7f17dbf214a270bc9967eed7d32
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
The hexiwear board has a k64 SoC, so we can reuse the k64 pinmux driver
and just add a new pinmux table for the board.
Jira: ZEP-716
Change-Id: I936691b3578db298014f44fe18433d7943b431f3
Signed-off-by: Maureen Helm <maureen.helm@nxp.com>
Paul Sokolovsky