There is a choice to log btmon logs over UART or RTT.
You can choose number of RTT buffer, set its name and size.
Replaced CONFIG_BT_DEBUG_MONITOR with CONFIG_BT_DEBUG_MONITOR_UART
for UART usage and CONFIG_BT_DEBUG_MONITOR_RTT for RTT.
Signed-off-by: Magdalena Kasenberg <magdalena.kasenberg@codecoup.pl>
Populates the onoff server stubs in the Bluetooth Mesh sample, and
implements generic LED based hardware support to include more boards.
Fixes#31031.
Signed-off-by: Trond Einar Snekvik <Trond.Einar.Snekvik@nordicsemi.no>
Allocates segmented message buffers as slabs in a common pool for RX and
TX. This reduces memory requirements for both TX and RX, as TX messages
can be stored without the network and advertising buffer overhead, and
RX can use only the slabs it needs, instead of allocating a full size
segmented message. This approach also removes the need for decrypting
the segments for each retransmission, reducing overall processing load.
Slab based segmentation for tx also introduces queuing of segmented
messages, which allows the application layer to send multiple messages
to the same destination without violating Bluetooth Mesh specification
v1.0.1, section 3.6.4.1. This mechanism is provided through a flag that
blocks segmented messages to a destination which a message is already
being sent to until the previous message finishes.
This changes the SDU size configuration to a symmetrical
RX_SEG_MAX/TX_SEG_MAX pair of configurations, plus a new segment pool
side configuration. It also removes the binding between the TX_SEG_MAX
config and the advertising buffers, reducing the minimum advertising
buffer count from 6 to 3.
Signed-off-by: Trond Einar Snekvik <Trond.Einar.Snekvik@nordicsemi.no>
Split Link Layer implementation uses 80 bytes more ISR stack
in comparison to Legacy Link Layer, hence increase the
required ISR_STACK_SIZE for the BBC micro:bit and other
nRF51 QFAA SoC based mesh and mesh_demo samples.
Fixes#20414.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Renames the nrf51_blenano config file to something generic and uses that
same config for the nrf51_ble400 board, which has the same constraints.
Cannot rely on the CONFIG_SOC_NRF51_QFAA variable, as the CONF_FILE
variable must be set before the boilerplate.
Signed-off-by: Trond Einar Snekvik <Trond.Einar.Snekvik@nordicsemi.no>
Magdalena Kasenberg