Add CONFIG_CRC for building CRC related routines.
CRC routines are now being built for each application, whether used or
not and are add in the build system unconditionally.
Keep CONFIG_CRC enabled by default for now and until all users have
converted to use the new option.
Partial fix for #50654
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Refactors all sensor drivers to use SENSOR_DEVICE_DT_INST_DEFINE, which
is a sensor-specific variant of DEVICE_DT_INST_DEFINE that provides a
common place to instantiate additional data structures for the future
sensor subsystem and/or sensor driver stats.
This approach was inspired by I2C_DEVICE_DT_INST_DEFINE to streamline
adding I2C stats support across all I2C drivers.
Signed-off-by: Maureen Helm <maureen.helm@intel.com>
This change in pattern is meant to address a misconfiguration issue
that can occur for sensors that support being on multiple busses
like I2C & SPI.
For example, you can have a configuration in which such a sensor is
on the I2C bus in the devicetree and the sensor is enabled. However
the application configuration enables CONFIG_SPI=y and CONFIG_I2C=n
and this will cause the sensor driver to be built by default, however
since we don't have the I2C bus enabled the driver will not compile
correctly.
Previously we had been adding to board Kconfig.defconfig something
like:
config I2C
default y if SENSOR
This pattern doesn't scale well and may differ from what an application
specific need/use is.
So instead move to a pattern in which we leave the default enablement
up to the devicetree "status" property for the sensor. We then have
the Kconfig move from 'depends on <BUS>' to 'select <BUS>' and in
the case of drivers that support multiple busses we have the Kconfig
be: 'select <BUS> if $(dt_compat_on_bus,$(<DT_COMPAT>),<BUS>) for
each bus type the sensor supports.
This removes the need to add Kconfig logic to each board and enables
the bus subsystem and bus controller driver if the sensor requires
it by default in the build system.
Fixes: #48518
Signed-off-by: Kumar Gala <galak@kernel.org>
Update sensor drivers to use DT_HAS_<compat>_ENABLED Kconfig symbol
to expose the driver and enable it by default based on devicetree.
Signed-off-by: Kumar Gala <galak@kernel.org>
Remove wrapper functions for getting i2c bus and i2c bus
address. This is done here to make it easier to move this
driver to i2c_dt_spec while still having clear separation
between commits.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
The measurement time in normal mode was too short.
With this commit the maximum value of the datasheet is applied.
Signed-off-by: Thomas Stranger <thomas.stranger@outlook.com>
In order to bring consistency in-tree, migrate all drivers to the new
prefix <zephyr/...>. Note that the conversion has been scripted, refer
to #45388 for more details.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Apply the same fix in bd8afe9365
(" drivers: sensor: clean up zephyr_library calls") to remove
redundant code in the sensor driver build system files. Additional
instances of the antipattern have crept in.
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
Add driver for sensirion consumer humidity sensor line.
Supports shtc1 and shtc3, but only shtc3 is tested.
Signed-off-by: Thomas Stranger <thomas.stranger@outlook.com>
Thomas Stranger