2017-04-05 03:20:40 +08:00
|
|
|
.. _blinky-sample:
|
|
|
|
|
|
2016-10-02 11:28:54 +08:00
|
|
|
Blinky Application
|
|
|
|
|
##################
|
|
|
|
|
|
|
|
|
|
Overview
|
2017-01-21 07:58:05 +08:00
|
|
|
********
|
2016-10-02 11:28:54 +08:00
|
|
|
|
|
|
|
|
The Blinky example shows how to configure GPIO pins as outputs which can also be
|
|
|
|
|
used to drive LEDs on the hardware usually delivered as "User LEDs" on many of
|
|
|
|
|
the supported boards in Zephyr.
|
2017-01-07 07:49:24 +08:00
|
|
|
|
|
|
|
|
Requirements
|
2017-01-21 07:58:05 +08:00
|
|
|
************
|
2017-01-07 07:49:24 +08:00
|
|
|
|
|
|
|
|
The demo assumes that an LED is connected to one of GPIO lines. The
|
|
|
|
|
sample code is configured to work on boards with user defined buttons and that
|
|
|
|
|
have defined the LED0\_* variables in :file:`board.h`.
|
|
|
|
|
|
|
|
|
|
The :file:`board.h` must define the following variables:
|
|
|
|
|
|
|
|
|
|
- LED0_GPIO_PORT
|
|
|
|
|
- LED0_GPIO_PIN
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Building and Running
|
2017-01-21 07:58:05 +08:00
|
|
|
********************
|
2017-01-07 07:49:24 +08:00
|
|
|
|
|
|
|
|
This samples does not output anything to the console. It can be built and
|
|
|
|
|
flashed to a board as follows:
|
|
|
|
|
|
|
|
|
|
.. code-block:: console
|
|
|
|
|
|
|
|
|
|
$ cd samples/basic/blinky
|
|
|
|
|
$ make BOARD=arduino_101
|
|
|
|
|
$ make BOARD=arduino_101 flash
|
|
|
|
|
|
|
|
|
|
After flashing the image to the board, the user LED on the board should start to
|
|
|
|
|
blink.
|
