zephyr/drivers/serial/Kconfig.esp32

menuconfig UART_ESP32
	bool "ESP32 UART driver"
	select SERIAL_HAS_DRIVER
	depends on SOC_ESP32
	help
	  Enable the ESP32 UART using ROM routines.
drivers: esp32: Add minimal UART driver based on ROM routines This is a minimal driver enabling console output during the port bringup. While the driver works, only one of the three UART devices are supported, and there isn't any way to change any parameters or use interrupts. This will most likely be superceded by a proper driver after the port has matured. Signed-off-by: Leandro Pereira <leandro.pereira@intel.com> 2017-05-11 08:12:12 +08:00			`menuconfig UART_ESP32`
			`bool "ESP32 UART driver"`
			`select SERIAL_HAS_DRIVER`
kconfig: serial: esp32: Make driver depend on SOC_ESP32 The ESP32 UART driver can only be used on the ESP32 SoC AFAICT. But it did not have a depend clause so it was polluting the options of other platforms. With this patch the ESP32 driver will no longer be exposed to users of non-ESP32 devices. Signed-off-by: Sebastian Bøe <sebastian.boe@nordicsemi.no> 2017-08-04 18:35:47 +08:00			`depends on SOC_ESP32`
drivers: esp32: Add minimal UART driver based on ROM routines This is a minimal driver enabling console output during the port bringup. While the driver works, only one of the three UART devices are supported, and there isn't any way to change any parameters or use interrupts. This will most likely be superceded by a proper driver after the port has matured. Signed-off-by: Leandro Pereira <leandro.pereira@intel.com> 2017-05-11 08:12:12 +08:00			`help`
kconfig: fix more help spacing issues Fix Kconfig help sections and add spacing to be consistent across all Kconfig file. In a previous run we missed a few. Signed-off-by: Anas Nashif <anas.nashif@intel.com> 2018-02-15 21:36:16 +08:00			`Enable the ESP32 UART using ROM routines.`
drivers: esp32: Add minimal UART driver based on ROM routines This is a minimal driver enabling console output during the port bringup. While the driver works, only one of the three UART devices are supported, and there isn't any way to change any parameters or use interrupts. This will most likely be superceded by a proper driver after the port has matured. Signed-off-by: Leandro Pereira <leandro.pereira@intel.com> 2017-05-11 08:12:12 +08:00