zephyr/boards/arm/nucleo_f746zg/nucleo_f746zg.yaml

identifier: nucleo_f746zg
name: NUCLEO-F746ZG
type: mcu
arch: arm
toolchain:
  - zephyr
  - gnuarmemb
ram: 320
flash: 1024
supported:
  - uart
  - gpio
  - netif:eth
  - usb_device
  - i2c
  - pwm
  - spi
boards: arm: nucleo_f746zg: Created new board Basic board with support for UART, 3 user LEDs and 1 user push-button switch. Signed-off-by: AJ Palmer <ajpcode@hotmail.com> 2018-10-24 05:12:20 +08:00			`identifier: nucleo_f746zg`
			`name: NUCLEO-F746ZG`
			`type: mcu`
			`arch: arm`
			`toolchain:`
			`- zephyr`
			`- gnuarmemb`
			`ram: 320`
			`flash: 1024`
			`supported:`
			`- uart`
			`- gpio`
boards: arm: nucleo_f746zg: Added ethernet support Added Kconfig.defconfig options, updated .yaml and documentation, added pinmux for required pins. Signed-off-by: AJ Palmer <ajpcode@hotmail.com> 2018-10-24 05:13:03 +08:00			`- netif:eth`
boards: arm: nucleo_f746zg: Added USB support Added Kconfig.defconfig options, updated .yaml and documentation, added pinmux for required pins. Signed-off-by: AJ Palmer <ajpcode@hotmail.com> 2018-10-24 05:13:50 +08:00			`- usb_device`
boards: arm: nucleo_f746zg: Added I2C support Added DT entry, Kconfig.defconfig options, updated .yaml and documentation, added pinmux for required pins. Signed-off-by: AJ Palmer <ajpcode@hotmail.com> 2018-10-24 05:14:40 +08:00			`- i2c`
boards: arm: nucleo_f746zg: Added PWM support Added support for PWM 1 on channel 3 (arduino pin D3). Signed-off-by: AJ Palmer <ajpcode@hotmail.com> 2018-10-24 05:15:49 +08:00			`- pwm`
boards: arm: nucleo_f746zg: Added SPI support Added support for SPI 1 available from the arduino connector (plus an extra gpio). Tested against samples/sensor/bme280. Signed-off-by: AJ Palmer <ajpcode@hotmail.com> 2018-10-24 05:17:39 +08:00			`- spi`