zephyr/drivers/interrupt_controller/Kconfig.xmc4xxx

# XMC4XXX INTC configuration

# Copyright (c) Schlumberger
# SPDX-License-Identifier: Apache-2.0

config XMC4XXX_INTC
	bool "Interrupt Controller Driver for XMC4XXX series devices"
	default y
	depends on DT_HAS_INFINEON_XMC4XXX_INTC_ENABLED
	help
	  Enable interrupt controller driver for XMC4XXX series of devices. This is required for
	  GPIO interrupt support.
drivers: interrupt_controller: Add XMC4XXX ERU driver In Infineon XMC4XXX SoCs, gpio interrupts are triggered via an Event Request Unit (ERU) module. A subset of the gpios are connected to the ERU. The ERU monitors edge triggers and creates a SR. This driver configures the ERU for a target port/pin combination for rising/falling edge events. Note that the ERU module does not generate SR based on the gpio level. Internally the ERU tracks the status of an event. The status is set on a positive edge and unset on a negative edge (or vice-versa depending on the configuration). The value of the status is used to implement a level triggered interrupt; The ISR checks the status flag and calls the callback function if the status is set. The ERU configurations for supported port/pin combinations are stored in a devicetree file dts/arm/infineon/xmc4xxx_x_x-intc.dtsi. The configurations are stored in the opaque array uint16 port_line_mapping[]. Signed-off-by: Andriy Gelman <andriy.gelman@gmail.com> 2022-07-22 02:33:28 +08:00			`# XMC4XXX INTC configuration`

			`# Copyright (c) Schlumberger`
			`# SPDX-License-Identifier: Apache-2.0`

			`config XMC4XXX_INTC`
			`bool "Interrupt Controller Driver for XMC4XXX series devices"`
			`default y`
			`depends on DT_HAS_INFINEON_XMC4XXX_INTC_ENABLED`
			`help`
			`Enable interrupt controller driver for XMC4XXX series of devices. This is required for`
			`GPIO interrupt support.`