zephyr/boards/u-blox/ubx_evkannab1/ubx_evkannab1_nrf52832_defc...

# u-blox EVK-ANNA-B1 board configuration

# Copyright (c) 2021 u-blox AG
# SPDX-License-Identifier: Apache-2.0

# Enable MPU
CONFIG_ARM_MPU=y

# Enable hardware stack protection
CONFIG_HW_STACK_PROTECTION=y

# Enable RTT
CONFIG_USE_SEGGER_RTT=y

# enable GPIO
CONFIG_GPIO=y

# enable uart driver
CONFIG_SERIAL=y

# enable console
CONFIG_CONSOLE=y
CONFIG_UART_CONSOLE=y
boards: arm: Add u-blox EVK-ANNA-B1 Add support for u-blox EVK-ANNA-B1 which uses the nRF52832. This board is similar to the nRF52dk_nrf52832 with different pin assignments on the header pins and not having the debug-in and shield SWD headers. Tested with blinky, button, and Bluetooth peripheral_hr Addressed review comments, including SW2 Rebased to pick up new board in test_adc.c - corrected typo Reverted to sda-pin, scl-pin Signed-off-by: Bob Recny <bob.recny@u-blox.com> 2021-04-03 05:16:07 +08:00			`# u-blox EVK-ANNA-B1 board configuration`

			`# Copyright (c) 2021 u-blox AG`
			`# SPDX-License-Identifier: Apache-2.0`

			`# Enable MPU`
			`CONFIG_ARM_MPU=y`

			`# Enable hardware stack protection`
			`CONFIG_HW_STACK_PROTECTION=y`

			`# Enable RTT`
			`CONFIG_USE_SEGGER_RTT=y`

			`# enable GPIO`
			`CONFIG_GPIO=y`

			`# enable uart driver`
			`CONFIG_SERIAL=y`

			`# enable console`
			`CONFIG_CONSOLE=y`
			`CONFIG_UART_CONSOLE=y`