30 lines
1.2 KiB
ReStructuredText
30 lines
1.2 KiB
ReStructuredText
|
Device Tree
|
||
|
|
###########
|
||
|
|
|
||
|
|
In the context of sensors device tree provides the initial hardware configuration
|
||
|
|
for sensors on a per device level. Each device must specify a device tree binding
|
||
|
|
in Zephyr, and ideally, a set of hardware configuration options for things such
|
||
|
|
as channel power modes, data rates, filters, decimation, and scales. These can
|
||
|
|
then be used in a boards devicetree to configure a sensor to its initial state.
|
||
|
|
|
||
|
|
.. code-block:: dts
|
||
|
|
|
||
|
|
#include <zephyr/dt-bindings/icm42688.h>
|
||
|
|
|
||
|
|
&spi0 {
|
||
|
|
/* SPI bus options here, not shown */
|
||
|
|
|
||
|
|
accel_gyro0: icm42688p@0 {
|
||
|
|
compatible = "invensense,icm42688";
|
||
|
|
reg = <0>;
|
||
|
|
int-gpios = <&pioc 6 GPIO_ACTIVE_HIGH>; /* SoC specific pin to select for interrupt line */
|
||
|
|
spi-max-frequency = <DT_FREQ_M(24)>; /* Maximum SPI bus frequency */
|
||
|
|
accel-pwr-mode = <ICM42688_ACCEL_LN>; /* Low noise mode */
|
||
|
|
accel-odr = <ICM42688_ACCEL_ODR_2000>; /* 2000 Hz sampling */
|
||
|
|
accel-fs = <ICM42688_ACCEL_FS_16>; /* 16G scale */
|
||
|
|
gyro-pwr-mode = <ICM42688_GYRO_LN>; /* Low noise mode */
|
||
|
|
gyro-odr = <ICM42688_GYRO_ODR_2000>; /* 2000 Hz sampling */
|
||
|
|
gyro-fs = <ICM42688_GYRO_FS_16>; /* 16G scale */
|
||
|
|
};
|
||
|
|
};
|