zephyr/drivers/i2c/Kconfig.sbcon

#
# Copyright (c) 2016 Linaro Ltd.
#
# SPDX-License-Identifier: Apache-2.0
#

menuconfig I2C_SBCON
	bool "I2C driver for ARM's SBCon two-wire serial bus interface"
	depends on ARM
	select I2C_BITBANG
i2c: i2c_sbcon: Driver for ARM's SBCon 2-wire serial interface SBCon is a simple device which allows directly setting and getting the hardware state of two-bit serial interfaces like I2C. Therefore to be useable we need to drive the lines with the appropriate protocol under software control. Change-Id: If9000bb75f7b0ad7bbb256b1cb38cc70fa6ca8ea Signed-off-by: Jon Medhurst <tixy@linaro.org> 2017-04-24 23:11:21 +08:00			`#`
			`# Copyright (c) 2016 Linaro Ltd.`
			`#`
			`# SPDX-License-Identifier: Apache-2.0`
			`#`

			`menuconfig I2C_SBCON`
			`bool "I2C driver for ARM's SBCon two-wire serial bus interface"`
drivers/i2c: kconfig: Clean up I2C Kconfigs a bit - Get rid of duplicate I2C dependencies, which show up in the documentation as e.g. 'I2C && I2C'. The 'source's in drivers/i2c/Kconfig are already within an 'if I2C' block. - Factor out I2C_GPIO_<n> dependencies in drivers/i2c/Kconfig.gpio into 'if I2C_GPIO_<n>' blocks. Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no> 2018-08-02 21:55:22 +08:00			`depends on ARM`
i2c: i2c_sbcon: Driver for ARM's SBCon 2-wire serial interface SBCon is a simple device which allows directly setting and getting the hardware state of two-bit serial interfaces like I2C. Therefore to be useable we need to drive the lines with the appropriate protocol under software control. Change-Id: If9000bb75f7b0ad7bbb256b1cb38cc70fa6ca8ea Signed-off-by: Jon Medhurst <tixy@linaro.org> 2017-04-24 23:11:21 +08:00			`select I2C_BITBANG`