/**
@page HAL_TimeBase_RTC_WKUP HAL TimeBase RTC WKUP
@verbatim
******************** (C) COPYRIGHT 2017 STMicroelectronics *******************
* @file HAL/HAL_TimeBase_RTC_WKUP/readme.txt
* @author MCD Application Team
* @brief Description of the HAL TimeBase RTC WKUP example.
******************************************************************************
* @attention
*
* Copyright (c) 2017 STMicroelectronics.
* All rights reserved.
*
* This software is licensed under terms that can be found in the LICENSE file
* in the root directory of this software component.
* If no LICENSE file comes with this software, it is provided AS-IS.
*
******************************************************************************
@endverbatim
@par Example Description
This example describes how to customize the HAL time base using RTC wakeup instead
of Systick as main source of time base. The nucleo board user button (connected to EXTI Line13)
will be used to Suspend or Resume tick increment.
Each time the user button is pressed; EXTI Line13 interrupt is generated and in the ISR
the uwIncrementState is checked:
1- If the uwIncrementState = 0: the tick increment is suspended by calling
HAL_SuspendTick() API (RTC wakeup timer interrupt is disabled).
2- If the uwIncrementState = 1: the tick increment is Resumed by calling
HAL_ResumeTick() API(RTC wakeup timer interrupt is enabled).
The wakeup feature is configured to assert an interrupt each 1ms
The example brings, in user file, a new implementation of the following HAL weak functions:
HAL_InitTick()
HAL_SuspendTick()
HAL_ResumeTick()
This implementation will overwrite native implementation in stm32f4xx_hal.c
and so user functions will be invoked instead when called.
The following time base functions are kept as implemented natively:
HAL_IncTick()
HAL_Delay()
In an infinite loop, LED1, LED2 and LED3 toggles spaced out over 500ms delay
@note Care must be taken when using HAL_Delay(), this function provides accurate delay (in milliseconds)
based on variable incremented in HAL time base ISR. This implies that if HAL_Delay() is called from
a peripheral ISR process, then the HAL time base interrupt must have higher priority (numerically lower)
than the peripheral interrupt. Otherwise the caller ISR process will be blocked.
To change the HAL time base interrupt priority you have to use HAL_NVIC_SetPriority() function.
@note The application needs to ensure that the HAL time base is always set to 1 millisecond
to have correct HAL operation.
@par Keywords
System, RTC Wakeup, Time base, HAL
@par Directory contents
- HAL/HAL_TimeBase/Inc/stm32f4xx_hal_conf.h HAL configuration file
- HAL/HAL_TimeBase/Inc/stm32f4xx_it.h Interrupt handlers header file
- HAL/HAL_TimeBase/Src/stm32f4xx_it.c Interrupt handlers
- HAL/HAL_TimeBase/Src/main.c Main program
- HAL/HAL_TimeBase/Src/stm32f4xx_hal_timebase_rtc_wkup.c HAL time base functions
- HAL/HAL_TimeBase/Src/system_stm32f4xx.c STM32F4xx system clock configuration file
@par Hardware and Software environment
- This example runs on STM32F446xx devices.
- This example has been tested with STMicroelectronics NUCLEO-446ZE Rev.B
boards and can be easily tailored to any other supported device
and development board.
@par How to use it ?
In order to make the program work, you must do the following :
- Open your preferred toolchain
- Rebuild all files and load your image into target memory
- Run the example
*/
3d6be4bd40