/**
@page Templates Description of the Templates example
@verbatim
******************** (C) COPYRIGHT 2016 STMicroelectronics *******************
* @file Templates/readme.txt
* @author MCD Application Team
* @brief Description of the Templates example.
******************************************************************************
* @attention
*
* Copyright (c) 2016 STMicroelectronics.
* All rights reserved.
*
* This software is licensed under terms that can be found in the LICENSE file
* in the root directory of this software component.
* If no LICENSE file comes with this software, it is provided AS-IS.
*
******************************************************************************
@endverbatim
@par Example Description
This projects provides a reference template that can be used to build any firmware application.
This project can be used for STM32F334R8 device using STM32CubeF3 HAL and running on STM32F334R8-Nucleo board
from STMicroelectronics.
STM32 Nucleo board's LED2 can be used to monitor the error: when Error_Handler is called, the LED2 toggles
with a frequency of 1Hz.
@note Care must be taken when using HAL_Delay(), this function provides accurate delay (in milliseconds)
based on variable incremented in SysTick ISR. This implies that if HAL_Delay() is called from
a peripheral ISR process, then the SysTick interrupt must have higher priority (numerically lower)
than the peripheral interrupt. Otherwise the caller ISR process will be blocked.
To change the SysTick interrupt priority you have to use HAL_NVIC_SetPriority() function.
@note The application need to ensure that the SysTick time base is always set to 1 millisecond
to have correct HAL operation.
@par Directory contents
- Templates/Src/main.c Main program
- Templates/Src/system_stm32f3xx.c STM32F3xx system clock configuration file
- Templates/Src/stm32f3xx_it.c Interrupt handlers
- Templates/Src/stm32f3xx_hal_msp.c HAL MSP module
- Templates/Inc/main.h Main program header file
- Templates/Inc/stm32f3xx_hal_conf.h HAL Configuration file
- Templates/Inc/stm32f3xx_it.h Interrupt handlers header file
@par Hardware and Software environment
- This example runs on STM32F334R8 device.
- This example has been tested with STMicroelectronics STM32F334R8-Nucleo RevC
boards and can be easily tailored to any other supported device
and development board.
@par How to use it ?
In order to make the program work, you must do the following :
- Open your preferred toolchain
- Rebuild all files and load your image into target memory
- Run the example
*/
e805a235c4