/**
@page ADC_AnalogWatchdog ADC example
@verbatim
******************** (C) COPYRIGHT 2016 STMicroelectronics *******************
* @file Examples_LL/ADC/ADC_AnalogWatchdog/readme.txt
* @author MCD Application Team
* @brief Description of the ADC_AnalogWatchdog example.
******************************************************************************
* @attention
*
* Copyright (c) 2016 STMicroelectronics.
* All rights reserved.
*
* This software is licensed under terms that can be found in the LICENSE file
* in the root directory of this software component.
* If no LICENSE file comes with this software, it is provided AS-IS.
*
******************************************************************************
@endverbatim
@par Example Description
How to use an ADC peripheral with an ADC analog watchdog to monitor a channel
and detect when the corresponding conversion data is outside the window
thresholds.
This example is based on the STM32F3xx ADC LL API.
The peripheral initialization is done using LL unitary service functions
for optimization purposes (performance and size).
Example configuration:
ADC is configured to convert a single channel, in continuous conversion mode,
from SW trigger.
Analog watchdog is configured to monitor all channels on group regular
(therefore, including the selected channel),
low threshold is set to 0V and high threshold is set to Vdda/2.
ADC interruption enabled: Analog watchdog 1.
Example execution:
From the main program execution, the ADC converts the selected channel continuously.
When conversion data is out of analog watchdog window, ADC interruption occurs.
Into analog watchdog callback function, a status variable is set
and a LED is turned-on.
At each press on push button, the ADC analog watchdog is rearmed to be ready
for another trig.
Note: In case of noise on voltage applied on ADC channel input, ADC analog watchdog
may trig at a voltage level with an uncertainty of tens of mV.
For debug: variables to monitor with debugger watch window:
- "ubAnalogWatchdog1Status": analog watchdog state
Connection needed:
None.
Note: Optionally, a voltage can be supplied to the analog input pin (cf pin below),
between 0V and Vdda=3.3V, to perform a ADC conversion on a determined
voltage level.
Otherwise, this pin can be let floating (in this case ADC conversion data
will be undetermined).
Other peripherals used:
1 GPIO for push button
1 GPIO for LED
1 GPIO for analog input: PA.04 (Arduino connector CN8 pin A2, Morpho connector CN7 pin 32)
@par Directory contents
- ADC/ADC_AnalogWatchdog/Inc/stm32f3xx_it.h Interrupt handlers header file
- ADC/ADC_AnalogWatchdog/Inc/main.h Header for main.c module
- ADC/ADC_AnalogWatchdog/Inc/stm32_assert.h Template file to include assert_failed function
- ADC/ADC_AnalogWatchdog/Src/stm32f3xx_it.c Interrupt handlers
- ADC/ADC_AnalogWatchdog/Src/main.c Main program
- ADC/ADC_AnalogWatchdog/Src/system_stm32f3xx.c STM32F3xx system source file
@par Hardware and Software environment
- This example runs on STM32F334xx devices.
- This example has been tested with STM32F334R8-Nucleo Rev C board and can be
easily tailored to any other supported device and development board.
@par How to use it ?
In order to make the program work, you must do the following :
- Open your preferred toolchain
- Rebuild all files and load your image into target memory
- Run the example
*/
e805a235c4