/**
@page PWR_EnterStopMode PWR standby example
@verbatim
******************** (C) COPYRIGHT 2016 STMicroelectronics *******************
* @file Examples_LL/PWR/PWR_EnterStopMode/readme.txt
* @author MCD Application Team
* @brief Description of the PWR STOP_LPREGU mode example.
******************************************************************************
* @attention
*
* Copyright (c) 2016 STMicroelectronics.
* All rights reserved.
*
* This software is licensed under terms that can be found in the LICENSE file
* in the root directory of this software component.
* If no LICENSE file comes with this software, it is provided AS-IS.
*
******************************************************************************
@endverbatim
@par Example Description
How to enter the system in STOP_LPREGU mode.
After start-up LED2 is toggling during 5 seconds, then the system automatically
enter in STOP_LPREGU mode (Final state).
LED2 is used to monitor the system state as follows:
- LED2 toggling : system in RUN mode
- LED2 off : system in STOP_LPREGU mode
@note To measure the current consumption in STOP_LPREGU mode, remove JP6 jumper
and connect an ampere meter to JP6 to measure IDD current.
@note This example can not be used in DEBUG mode due to the fact
that the Cortex-M0 core is no longer clocked during low power mode
so debugging features are disabled.
@par Directory contents
- PWR/PWR_EnterStopMode/Inc/stm32f0xx_it.h Interrupt handlers header file
- PWR/PWR_EnterStopMode/Inc/main.h Header for main.c module
- PWR/PWR_EnterStopMode/Inc/stm32_assert.h Template file to include assert_failed function
- PWR/PWR_EnterStopMode/Src/stm32f0xx_it.c Interrupt handlers
- PWR/PWR_EnterStopMode/Src/main.c Main program
- PWR/PWR_EnterStopMode/Src/system_stm32f0xx.c STM32F0xx system source file
@par Hardware and Software environment
- This example runs on STM32F072xB devices.
- This example has been tested with STMicroelectronics STM32F072RB-Nucleo RevC
board and can be easily tailored to any other supported device
and development board.
- STM32F072RB-Nucleo RevC Set-up
- LED2 connected to PA.05 pin
@par How to use it ?
In order to make the program work, you must do the following :
- Open your preferred toolchain
- Rebuild all files and load your image into target memory
- Run the example
*/
a58188598c