268 lines
8.7 KiB
C
268 lines
8.7 KiB
C
/****************************************************************************
|
|
* include/nuttx/audio/cs43l22.h
|
|
*
|
|
* SPDX-License-Identifier: Apache-2.0
|
|
*
|
|
* Licensed to the Apache Software Foundation (ASF) under one or more
|
|
* contributor license agreements. See the NOTICE file distributed with
|
|
* this work for additional information regarding copyright ownership. The
|
|
* ASF licenses this file to you under the Apache License, Version 2.0 (the
|
|
* "License"); you may not use this file except in compliance with the
|
|
* License. You may obtain a copy of the License at
|
|
*
|
|
* http://www.apache.org/licenses/LICENSE-2.0
|
|
*
|
|
* Unless required by applicable law or agreed to in writing, software
|
|
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
|
|
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
|
|
* License for the specific language governing permissions and limitations
|
|
* under the License.
|
|
*
|
|
****************************************************************************/
|
|
|
|
#ifndef __INCLUDE_NUTTX_AUDIO_CS43L22_H
|
|
#define __INCLUDE_NUTTX_AUDIO_CS43L22_H
|
|
|
|
/****************************************************************************
|
|
* Included Files
|
|
****************************************************************************/
|
|
|
|
#include <stdint.h>
|
|
#include <stdbool.h>
|
|
|
|
#include <nuttx/irq.h>
|
|
|
|
#ifdef CONFIG_AUDIO_CS43L22
|
|
|
|
/****************************************************************************
|
|
* Pre-processor Definitions
|
|
****************************************************************************/
|
|
|
|
/* Configuration ************************************************************
|
|
*
|
|
* CONFIG_AUDIO_CS43L22 - Enables CS43L22 support
|
|
* CONFIG_CS43L22_INITVOLUME - The initial volume level
|
|
* in the range {0..1000}
|
|
* CONFIG_CS43L22_INFLIGHT - Maximum number of buffers that the CS43L22
|
|
* driver will send to the I2S driver before any have completed.
|
|
* CONFIG_CS43L22_MSG_PRIO - Priority of messages sent to the CS43L22
|
|
* worker thread.
|
|
* CONFIG_CS43L22_BUFFER_SIZE - Preferred buffer size
|
|
* CONFIG_CS43L22_NUM_BUFFERS - Preferred number of buffers
|
|
* CONFIG_CS43L22_WORKER_STACKSIZE - Stack size to use when creating the the
|
|
* CS43L22 worker thread.
|
|
* CONFIG_CS43L22_REGDUMP - Enable logic to dump all CS43L22 registers to
|
|
* the SYSLOG device.
|
|
*/
|
|
|
|
/* Pre-requisites */
|
|
|
|
#ifndef CONFIG_AUDIO
|
|
# error CONFIG_AUDIO is required for audio subsystem support
|
|
#endif
|
|
|
|
#ifndef CONFIG_I2S
|
|
# error CONFIG_I2S is required by the CS43L22 driver
|
|
#endif
|
|
|
|
#ifndef CONFIG_I2C
|
|
# error CONFIG_I2C is required by the CS43L22 driver
|
|
#endif
|
|
|
|
#ifndef CONFIG_SCHED_WORKQUEUE
|
|
# error CONFIG_SCHED_WORKQUEUE is required by the CS43L22 driver
|
|
#endif
|
|
|
|
/* Default configuration values */
|
|
|
|
#ifndef CONFIG_CS43L22_INITVOLUME
|
|
# define CONFIG_CS43L22_INITVOLUME 400
|
|
#endif
|
|
|
|
#ifndef CONFIG_CS43L22_INFLIGHT
|
|
# define CONFIG_CS43L22_INFLIGHT 2
|
|
#endif
|
|
|
|
#if CONFIG_CS43L22_INFLIGHT > 255
|
|
# error CONFIG_CS43L22_INFLIGHT must fit in a uint8_t
|
|
#endif
|
|
|
|
#ifndef CONFIG_CS43L22_MSG_PRIO
|
|
# define CONFIG_CS43L22_MSG_PRIO 1
|
|
#endif
|
|
|
|
#ifndef CONFIG_CS43L22_BUFFER_SIZE
|
|
# define CONFIG_CS43L22_BUFFER_SIZE 8192
|
|
#endif
|
|
|
|
#ifndef CONFIG_CS43L22_NUM_BUFFERS
|
|
# define CONFIG_CS43L22_NUM_BUFFERS 4
|
|
#endif
|
|
|
|
#ifndef CONFIG_CS43L22_WORKER_STACKSIZE
|
|
# define CONFIG_CS43L22_WORKER_STACKSIZE 768
|
|
#endif
|
|
|
|
/* Helper macros ************************************************************/
|
|
|
|
#define CS43L22_ATTACH(s,isr,arg) ((s)->attach(s,isr,arg))
|
|
#define CS43L22_DETACH(s) ((s)->attach(s,NULL,NULL))
|
|
#define CS43L22_ENABLE(s) ((s)->enable(s,true))
|
|
#define CS43L22_DISABLE(s) ((s)->enable(s,false))
|
|
#define CS43L22_RESTORE(s,e) ((s)->enable(s,e))
|
|
#define CS43L22_HW_RESET(s) ((s)->reset(s))
|
|
|
|
/****************************************************************************
|
|
* Public Types
|
|
****************************************************************************/
|
|
|
|
/* This is the type of the CS43L22 interrupt handler. The lower level code
|
|
* will intercept the interrupt and provide the upper level with the private
|
|
* data that was provided when the interrupt was attached.
|
|
*/
|
|
|
|
struct cs43l22_lower_s; /* Forward reference. Defined below */
|
|
|
|
typedef CODE int (*cs43l22_handler_t)
|
|
(FAR const struct cs43l22_lower_s *lower,
|
|
FAR void *arg);
|
|
|
|
/* A reference to a structure of this type must be passed to the CS43L22
|
|
* driver. This structure provides information about the configuration
|
|
* of the CS43L22 and provides some board-specific hooks.
|
|
*
|
|
* Memory for this structure is provided by the caller. It is not copied
|
|
* by the driver and is presumed to persist while the driver is active.
|
|
*/
|
|
|
|
struct cs43l22_lower_s
|
|
{
|
|
/* I2C characterization */
|
|
|
|
uint32_t frequency; /* Initial I2C frequency */
|
|
uint8_t address; /* 7-bit I2C address (only bits 0-6 used) */
|
|
|
|
/* Clocking is provided via MCLK. The CS43L22 driver will need to know
|
|
* the frequency of MCLK in order to generate the correct bitrates.
|
|
*/
|
|
|
|
uint32_t mclk; /* CS43L22 Master clock frequency */
|
|
|
|
/* IRQ/GPIO access callbacks. These operations all hidden behind
|
|
* callbacks to isolate the CS43L22 driver from differences in GPIO
|
|
* interrupt handling by varying boards and MCUs. If possible,
|
|
* interrupts should be configured on both rising and falling edges
|
|
* so that contact and loss-of-contact events can be detected.
|
|
*
|
|
* attach - Attach or detach the CS43L22 interrupt handler to the GPIO
|
|
* interrupt
|
|
* enable - Enable or disable the GPIO interrupt. Returns the
|
|
* previous interrupt state.
|
|
* reset - HW reset of the CS43L22 chip
|
|
*/
|
|
|
|
CODE int (*attach)(FAR const struct cs43l22_lower_s *lower,
|
|
cs43l22_handler_t isr, FAR void *arg);
|
|
CODE bool (*enable)(FAR const struct cs43l22_lower_s *lower, bool enable);
|
|
CODE void (*reset)(FAR const struct cs43l22_lower_s *lower);
|
|
};
|
|
|
|
/****************************************************************************
|
|
* Public Data
|
|
****************************************************************************/
|
|
|
|
#ifdef __cplusplus
|
|
#define EXTERN extern "C"
|
|
extern "C"
|
|
{
|
|
#else
|
|
#define EXTERN extern
|
|
#endif
|
|
|
|
/****************************************************************************
|
|
* Public Function Prototypes
|
|
****************************************************************************/
|
|
|
|
/****************************************************************************
|
|
* Name: cs43l22_initialize
|
|
*
|
|
* Description:
|
|
* Initialize the CS43L22 device.
|
|
*
|
|
* Input Parameters:
|
|
* i2c - An I2C driver instance
|
|
* i2s - An I2S driver instance
|
|
* lower - Persistent board configuration data
|
|
*
|
|
* Returned Value:
|
|
* A new lower half audio interface for the CS43L22 device is returned on
|
|
* success; NULL is returned on failure.
|
|
*
|
|
****************************************************************************/
|
|
|
|
struct i2c_master_s; /* Forward reference. Defined in include/nuttx/i2c/i2c_master.h */
|
|
struct i2s_dev_s; /* Forward reference. Defined in include/nuttx/audio/i2s.h */
|
|
struct audio_lowerhalf_s; /* Forward reference. Defined in nuttx/audio/audio.h */
|
|
|
|
FAR struct audio_lowerhalf_s *
|
|
cs43l22_initialize(FAR struct i2c_master_s *i2c, FAR struct i2s_dev_s *i2s,
|
|
FAR const struct cs43l22_lower_s *lower);
|
|
|
|
/****************************************************************************
|
|
* Name: cs43l22_dump_registers
|
|
*
|
|
* Description:
|
|
* Dump the contents of all CS43L22 registers to the syslog device
|
|
*
|
|
* Input Parameters:
|
|
* dev - The device instance returned by cs43l22_initialize
|
|
*
|
|
* Returned Value:
|
|
* None.
|
|
*
|
|
****************************************************************************/
|
|
|
|
#ifdef CONFIG_CS43L22_REGDUMP
|
|
void cs43l22_dump_registers(FAR struct audio_lowerhalf_s *dev,
|
|
FAR const char *msg);
|
|
#else
|
|
/* This eliminates the need for any conditional compilation in the
|
|
* including file.
|
|
*/
|
|
|
|
# define cs43l22_dump_registers(d,m)
|
|
#endif
|
|
|
|
/****************************************************************************
|
|
* Name: cs43l22_clock_analysis
|
|
*
|
|
* Description:
|
|
* Analyze the settings in the clock chain and dump to syslog.
|
|
*
|
|
* Input Parameters:
|
|
* dev - The device instance returned by cs43l22_initialize
|
|
*
|
|
* Returned Value:
|
|
* None.
|
|
*
|
|
****************************************************************************/
|
|
|
|
#ifdef CONFIG_CS43L22_CLKDEBUG
|
|
void cs43l22_clock_analysis(FAR struct audio_lowerhalf_s *dev,
|
|
FAR const char *msg);
|
|
#else
|
|
/* This eliminates the need for any conditional compilation in the
|
|
* including file.
|
|
*/
|
|
|
|
# define cs43l22_clock_analysis(d,m)
|
|
#endif
|
|
|
|
#undef EXTERN
|
|
#ifdef __cplusplus
|
|
}
|
|
#endif
|
|
|
|
#endif /* CONFIG_AUDIO_CS43L22 */
|
|
#endif /* __INCLUDE_NUTTX_AUDIO_CS43L22_H */
|