incubator-nuttx/include/nuttx/audio/vs1053.h

113 lines
3.9 KiB
C

/****************************************************************************
* include/nuttx/audio/vs1053.h
*
* Licensed to the Apache Software Foundation (ASF) under one or more
* contributor license agreements. See the NOTICE file distributed with
* this work for additional information regarding copyright ownership. The
* ASF licenses this file to you under the Apache License, Version 2.0 (the
* "License"); you may not use this file except in compliance with the
* License. You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
* License for the specific language governing permissions and limitations
* under the License.
*
****************************************************************************/
#ifndef __INCLUDE_NUTTX_AUDIO_VS1053_H
#define __INCLUDE_NUTTX_AUDIO_VS1053_H
/****************************************************************************
* Included Files
****************************************************************************/
#include <stdint.h>
#include <stdbool.h>
#include <nuttx/irq.h>
/****************************************************************************
* Pre-processor Definitions
****************************************************************************/
/* VS1053 Configuration Settings:
*
* CONFIG_AUDIO_VS1053 - Enabled VS1053 support
* CONFIG_VS1053_SPIMODE - Controls the SPI mode
*/
/****************************************************************************
* Public Types
****************************************************************************/
/* The VS1053 provides Data Request (DREQ) interrupts to the MCU via a GPIO
* pin and also has a chip reset GPIO. The following structure provides an
* MCU-independent mechanism for controlling the VS1053 GPIOs.
*/
struct vs1053_lower_s
{
int (*attach)(FAR const struct vs1053_lower_s *lower, xcpt_t handler,
FAR void *arg);
void (*enable)(FAR const struct vs1053_lower_s *lower);
void (*disable)(FAR const struct vs1053_lower_s *lower);
void (*reset)(FAR const struct vs1053_lower_s *lower, bool state);
int (*read_dreq)(FAR const struct vs1053_lower_s *lower);
int irq;
};
/****************************************************************************
* Public Data
****************************************************************************/
#ifdef __cplusplus
#define EXTERN extern "C"
extern "C"
{
#else
#define EXTERN extern
#endif
/****************************************************************************
* Public Function Prototypes
****************************************************************************/
/****************************************************************************
* Name: vs1053_initialize
*
* Description:
* Initialize the VS1053 driver. This will perform a chip reset of the
* device as part of initialization.
*
* Input Parameters:
* spi - A reference to the platform's SPI driver for the VS1053
* lower - The MCU-specific interrupt used to control low-level MCU
* functions (i.e., VS1053 GPIO interrupts).
* devno - If more than one VS1053 is supported, then this is the
* zero based number that identifies the VS1053;
*
* Returned Value:
* OK on success; Negated errno on failure.
*
* Assumptions:
*
****************************************************************************/
struct spi_dev_s; /* See nuttx/spi/spi.h */
struct audio_lowerhalf_s; /* See nuttx/audio/audio.h */
FAR struct audio_lowerhalf_s *vs1053_initialize(FAR struct spi_dev_s *spi,
FAR const struct vs1053_lower_s *lower,
unsigned int devno);
#undef EXTERN
#ifdef __cplusplus
}
#endif
#endif /* __INCLUDE_NUTTX_AUDIO_VS1053_H */