incubator-nuttx/drivers/wireless/ISM1_868MHzGFSK100kbps.c

117 lines
4.8 KiB
C
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

/****************************************************************************
* drivers/wireless/ISM1_868MHzGFSK100kbps.c
*
* Licensed to the Apache Software Foundation (ASF) under one or more
* contributor license agreements. See the NOTICE file distributed with
* this work for additional information regarding copyright ownership. The
* ASF licenses this file to you under the Apache License, Version 2.0 (the
* "License"); you may not use this file except in compliance with the
* License. You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
* License for the specific language governing permissions and limitations
* under the License.
*
****************************************************************************/
/****************************************************************************
* Included Files
****************************************************************************/
#include <nuttx/wireless/cc1101.h>
/****************************************************************************
* Public Data
****************************************************************************/
/* Settings for 868 MHz, GFSK at 100kbps
*
* ISM Region 1 (Europe) only, Band 868870 MHz
*
* Frequency ERP Duty Cycle Bandwidth Remarks
* 868 868.6 MHz +14 dBm < 1% No limits
* 868.7 869.2 MHz +14 dBm < 0.1% No limits
* 869.3 869.4 MHz +10 dBm No limits < 25 kHz Appropriate access
* protocol required
* 869.4 869.65 MHz +27 dBm < 10% < 25 kHz Channels may be
* combined to one
* high speed channel
* 869.7 -870 MHz +7 dBm No limits No limits
*
* Deviation = 46.142578
* Base frequency = 867.999985
* Carrier frequency = 867.999985
* Channel number = 0
* Carrier frequency = 867.999985
* Modulated = true
* Modulation format = GFSK
* Manchester enable = false
* Sync word qualifier mode = 30/32 sync word bits detected
* Preamble count = 4
* Channel spacing = 199.813843
* Carrier frequency = 867.999985
* Data rate = 99.9069
* RX filter BW = 210.937500
* Data format = Normal mode
* Length config = Fixed packet length mode.
* Length configured in PKTLEN register
* CRC enable = true
* Packet length = 62
* Device address = 00
* Address config = NO Address check, no broadcast
* CRC autoflush = true
* PA ramping = false
* TX power = 0
*/
const struct c1101_rfsettings_s cc1101_rfsettings_ISM1_868MHzGFSK100kbps =
{
.FSCTRL1 = 0x08, /* FSCTRL1 Frequency Synthesizer Control */
.FSCTRL0 = 0x00, /* FSCTRL0 Frequency Synthesizer Control */
.FREQ2 = 0x20, /* FREQ2 Frequency Control Word, High Byte */
.FREQ1 = 0x25, /* FREQ1 Frequency Control Word, Middle Byte */
.FREQ0 = 0xed, /* FREQ0 Frequency Control Word, Low Byte */
.MDMCFG4 = 0x8b, /* MDMCFG4 Modem Configuration */
.MDMCFG3 = 0xe5, /* MDMCFG3 Modem Configuration */
.MDMCFG2 = 0x13, /* MDMCFG2 Modem Configuration */
.MDMCFG1 = 0x22, /* MDMCFG1 Modem Configuration */
.MDMCFG0 = 0xe5, /* MDMCFG0 Modem Configuration */
.DEVIATN = 0x46, /* DEVIATN Modem Deviation Setting */
.FOCCFG = 0x1d, /* FOCCFG Frequency Offset Compensation Configuration */
.BSCFG = 0x1c, /* BSCFG Bit Synchronization Configuration */
.AGCCTRL2 = 0xc7, /* AGCCTRL2 AGC Control */
.AGCCTRL1 = 0x00, /* AGCCTRL1 AGC Control */
.AGCCTRL0 = 0xb2, /* AGCCTRL0 AGC Control */
.FREND1 = 0xb6, /* FREND1 Front End RX Configuration */
.FREND0 = 0x10, /* FREND0 Front End TX Configuration */
.FSCAL3 = 0xea, /* FSCAL3 Frequency Synthesizer Calibration */
.FSCAL2 = 0x2a, /* FSCAL2 Frequency Synthesizer Calibration */
.FSCAL1 = 0x00, /* FSCAL1 Frequency Synthesizer Calibration */
.FSCAL0 = 0x1f, /* FSCAL0 Frequency Synthesizer Calibration */
.CHMIN = 0, /* Fix at 9th channel: 869.80 MHz +- 100 kHz RF Bandwidth */
.CHMAX = 9, /* single channel */
.PAMAX = 8, /* 0 means power OFF, 8 represents PA[7] */
.PA =
{
0x03, 0x0f, 0x1e, 0x27, 0x67, 0x50, 0x81, 0xc2
}
};
/****************************************************************************
* Public Functions
****************************************************************************/