/**************************************************************************** * include/nuttx/usb/fusb301.h * FUSB301 USB type-C controller driver * * Copyright (C) 2016-2017 Haltian Ltd. All rights reserved. * Authors: Harri Luhtala * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in * the documentation and/or other materials provided with the * distribution. * 3. Neither the name NuttX nor the names of its contributors may be * used to endorse or promote products derived from this software * without specific prior written permission. * * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS * FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE * COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, * BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS * OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED * AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN * ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE * POSSIBILITY OF SUCH DAMAGE. * ****************************************************************************/ #ifndef __INCLUDE_NUTTX_USB_FUSB301_H #define __INCLUDE_NUTTX_USB_FUSB301_H #include /************************************************************************************ * Pre-Processor Declarations ************************************************************************************/ #undef EXTERN #if defined(__cplusplus) #define EXTERN extern "C" extern "C" { #else #define EXTERN extern #endif /************************************************************************************ * Pre-processor Definitions ************************************************************************************/ /* IOCTL Commands ***********************************************************/ #define USBCIOC_READ_DEVID _USBCIOC(0x0001) /* Arg: uint8_t* pointer */ #define USBCIOC_SETUP _USBCIOC(0x0002) /* Arg: uint8_t* pointer */ #define USBCIOC_SET_MODE _USBCIOC(0x0003) /* Arg: uint8_t value */ #define USBCIOC_SET_STATE _USBCIOC(0x0004) /* Arg: uint8_t value */ #define USBCIOC_READ_STATUS _USBCIOC(0x0005) /* Arg: uint8_t* pointer*/ #define USBCIOC_READ_DEVTYPE _USBCIOC(0x0006) /* Arg: uint8_t* pointer*/ #define USBCIOC_RESET _USBCIOC(0x0007) /* Arg: None */ /************************************************************************************ * Public Types ************************************************************************************/ enum fusb301_reg_address_e { FUSB301_DEV_ID_REG = 0x01, FUSB301_MODE_REG, FUSB301_CONTROL_REG, FUSB301_MANUAL_REG, FUSB301_RESET_REG, FUSB301_MASK_REG = 0x10, FUSB301_STATUS_REG, FUSB301_TYPE_REG, FUSB301_INTERRUPT_REG }; /* Device ID - 0x01 */ enum fusb301_devid_mask_e { DEV_ID_REVISION_MASK = 0x0F, DEV_ID_VERSION_MASK = 0xF0 }; #define DEV_ID_VER_A 0x10 #define DEV_ID_REV_C 0x02 /* Modes - 0x02 */ enum fusb301_mode_e { MODE_SRC = (1 << 0), MODE_SRC_ACC = (1 << 1), MODE_SNK = (1 << 2), MODE_SNK_ACC = (1 << 3), MODE_DRP = (1 << 4), MODE_DRP_ACC = (1 << 5) }; /* Control - 0x03 */ enum fusb301_control_e { CONTROL_INT_ENABLE = (0 << 0), CONTROL_INT_DISABLE = (1 << 0), CONTROL_CUR_DISABLED = (0 << 1), CONTROL_CUR_DEFAULT = (1 << 1), CONTROL_CUR_1500 = (2 << 1), CONTROL_CUR_3000 = (3 << 1), CONTROL_TGL_35_15MS = (0 << 4), CONTROL_TGL_30_20MS = (1 << 4), CONTROL_TGL_25_25MS = (2 << 4), CONTROL_TGL_20_30MS = (3 << 4) }; /* Manual - 0x04 */ enum fusb301_manual_e { MANUAL_ERROR_REC = (1 << 0), MANUAL_DISABLED = (1 << 1), MANUAL_UNATT_SRC = (1 << 2), MANUAL_UNATT_SNK = (1 << 3) }; /* Reset - 0x05 */ enum fusb301_reset_e { RESET_SW_RES = (1 << 0) }; /* Interrupt mask - 0x10 */ enum fusb301_int_mask_e { INT_MASK_ATTACK = (1 << 0), INT_MASK_DETACH = (1 << 1), INT_MASK_BC_LVL = (1 << 2), INT_MASK_ACC_CH = (1 << 3) }; /* Status - 0x11 */ enum fusb301_status_e { STATUS_ATTACH = (1 << 0), STATUS_BC_SINK_UNATT = (0 << 1), STATUS_BC_SINK_DEF = (1 << 1), STATUS_BC_SINK_1500 = (2 << 1), STATUS_BC_SINK_3000 = (3 << 1), STATUS_VBUS_OK = (1 << 3), STATUS_CC_NO_CONN = (0 << 4), STATUS_CC_1 = (1 << 4), STATUS_CC_2 = (2 << 4), STATUS_CC_FAULT = (3 << 4) }; /* Type - 0x12 */ enum fusb301_type_e { TYPE_AUDIOACC = (1 << 0), TYPE_DEBUGACC = (1 << 1), TYPE_SOURCE = (1 << 3), TYPE_SINK = (1 << 4) }; /* Interrupt - 0x13 */ enum fusb301_interrupt_e { INTERRUPT_ATTACH = (1 << 0), INTERRUPT_DETACH = (1 << 1), INTERRUPT_BC_LVL = (1 << 2), INTERRUPT_ACC_CH = (1 << 3) }; struct fusb301_result_s { uint8_t status; uint8_t dev_type; }; struct fusb301_setup_s { uint8_t drp_toggle_timing; uint8_t host_current; uint8_t int_mask; bool global_int_mask; }; struct fusb301_config_s { /* Device characterization */ int irq; CODE int (*irq_attach)(FAR struct fusb301_config_s *state, xcpt_t isr, FAR void *arg); CODE void (*irq_enable)(FAR struct fusb301_config_s *state, bool enable); CODE void (*irq_clear)(FAR struct fusb301_config_s *state); }; /************************************************************************************ * Public Function Prototypes ************************************************************************************/ /**************************************************************************** * Name: fusb301_register * * Description: * Register the FUSB301 character device as 'devpath' * * Input Parameters: * devpath - The full path to the driver to register. E.g., "/dev/usbc0" * i2c - An instance of the I2C interface to use to communicate with FUSB301 * addr - The I2C address of the FUSB301. The I2C address of the FUSB301 is 0x25. * config - Pointer to FUSB301 configuration * * Returned Value: * Zero (OK) on success; a negated errno value on failure. * ****************************************************************************/ int fusb301_register(FAR const char *devpath, FAR struct i2c_master_s *i2c, uint8_t addr, FAR struct fusb301_config_s *config); #undef EXTERN #if defined(__cplusplus) } #endif #endif /* __INCLUDE_NUTTX_USB_FUSB301_H */