A device driver based on drivers/net/skeleton.c, which uses the W5500 in
MACRAW mode (i.e. bypassing the integrated protocol stack).
Signed-off-by: Michael Jung <michael.jung@secore.ly>
This directive tells the compiler that cromfs_node_s might be located at a memory
address which is not word aligned. This resolves the hardFault caused by unaligned
memory access on armv6-m architecture which doesn't support it.
The driver is provided by Spresense SDK
ISX019 has the DOL-HDR feature, which combines images with different exposure so that
both bright and dark data of high-contrast subject can be viewed at the same time.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
jumping back to the assembly signal trampoline and getting into its
infinite loop.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
Change pin initialization timing for camera from board power on to camera device
power on for the following purposes.
- avoid unnecessary power consumption
- Make the corresponding pins available for other uses when camera is not in use
RF and system timer interrupt are used for ble.
tlsr82_flash.c:
1. BLE will loss packets during flash operation beacause the interrupt
is disabled and the operation take too long (especially erasing,
about 100ms), so allow RF and system timer interrupt during flash
operation;
2. Add sched_lock()/sched_unlock() to avoid the task switch in ble and
system timer interrupt;
flash_boot_ble.ld:
3. Because of 1, the code executes in RF and system timer interrupt
must be in ram to avoid bus error. The sem_post() will be called and
const variable g_tasklisttable will be accessed in RF and system
timer interrupt handler;
4. To improve the performance, copy some frequently called function to
ram as well, such as: sem_take(), sched_lock(), sched_unlock(),
some lib functions, some zephyr ble functions and some tinycrypt
functions;
5. The RF and system timer interrupt handler will call some libgcc
functions, so copy all the libgcc functions to ram exclude _divdi3.o,
_udivdi3.o and _umoddi3.o;
tlsr82_serial.c
6. Make up_putc() be thread safe, add enter/leave_critical_section() in
function uart_send_byte();
tc32_doirq.c
7. Increase the RF and system timer interrupt response priority;
Signed-off-by: wangbowen6 <wangbowen6@xiaomi.com>
since the code could map the unsupported work to the
supported one and remove select SCHED_WORKQUEUE from
Kconfig since SCHED_[L|H]PWORK already do the selection
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
since _exit may kill all sibling thread when
HAVE_GROUP_MEMBERS equal true. Regressed by:
commit 622677d4a1
Author: Ville Juven <ville.juven@unikie.com>
Date: Mon May 2 15:15:06 2022 +0300
libc: Implement exit, atexit, on_exit and cxa_exit on the user side
For CONFIG_BUILD_KERNEL using the sched/task/task_exithook implementation
will just not work. It calls user code with kernel privileges which is
a bit of a security issue.
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
chao.an