167 lines
6.0 KiB
C
167 lines
6.0 KiB
C
|
/****************************************************************************
|
||
|
|
* drivers/ioexpander/mcp23x08.h
|
||
|
|
*
|
||
|
|
* Licensed to the Apache Software Foundation (ASF) under one or more
|
||
|
|
* contributor license agreements. See the NOTICE file distributed with
|
||
|
|
* this work for additional information regarding copyright ownership. The
|
||
|
|
* ASF licenses this file to you under the Apache License, Version 2.0 (the
|
||
|
|
* "License"); you may not use this file except in compliance with the
|
||
|
|
* License. You may obtain a copy of the License at
|
||
|
|
*
|
||
|
|
* http://www.apache.org/licenses/LICENSE-2.0
|
||
|
|
*
|
||
|
|
* Unless required by applicable law or agreed to in writing, software
|
||
|
|
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
|
||
|
|
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
|
||
|
|
* License for the specific language governing permissions and limitations
|
||
|
|
* under the License.
|
||
|
|
*
|
||
|
|
****************************************************************************/
|
||
|
|
|
||
|
|
#ifndef __DRIVERS_IOEXPANDER_MCP23X08_H
|
||
|
|
#define __DRIVERS_IOEXPANDER_MCP23X08_H
|
||
|
|
|
||
|
|
/****************************************************************************
|
||
|
|
* Included Files
|
||
|
|
****************************************************************************/
|
||
|
|
|
||
|
|
#include <nuttx/config.h>
|
||
|
|
|
||
|
|
#include <nuttx/wdog.h>
|
||
|
|
#include <nuttx/clock.h>
|
||
|
|
#include <nuttx/mutex.h>
|
||
|
|
#include <nuttx/wqueue.h>
|
||
|
|
#include <nuttx/ioexpander/ioexpander.h>
|
||
|
|
#include <nuttx/ioexpander/mcp23x08.h>
|
||
|
|
|
||
|
|
#include <nuttx/i2c/i2c_master.h>
|
||
|
|
#include <nuttx/irq.h>
|
||
|
|
|
||
|
|
#if defined(CONFIG_IOEXPANDER) && defined(CONFIG_IOEXPANDER_MCP23X08)
|
||
|
|
|
||
|
|
/****************************************************************************
|
||
|
|
* Pre-processor Definitions
|
||
|
|
****************************************************************************/
|
||
|
|
|
||
|
|
/* Configuration ************************************************************/
|
||
|
|
|
||
|
|
/* Prerequisites:
|
||
|
|
* CONFIG_I2C
|
||
|
|
* I2C support is required
|
||
|
|
* CONFIG_IOEXPANDER
|
||
|
|
* Enables I/O expander support
|
||
|
|
*
|
||
|
|
* CONFIG_IOEXPANDER_MCP23X08
|
||
|
|
* Enables support for the MCP23X08 driver (Needs CONFIG_INPUT)
|
||
|
|
* CONFIG_MCP23X08_MULTIPLE
|
||
|
|
* Can be defined to support multiple MCP23X08 devices on board.
|
||
|
|
* CONFIG_MCP23X08_INT_NCALLBACKS
|
||
|
|
* Maximum number of supported pin interrupt callbacks.
|
||
|
|
* CONFIG_MCP23X08_INT_POLL
|
||
|
|
* Enables a poll for missed interrupts
|
||
|
|
* CONFIG_MCP23X08_INT_POLLDELAY
|
||
|
|
* If CONFIG_MCP23X08_INT_POLL=y, then this is the delay in microseconds
|
||
|
|
* between polls for missed interrupts.
|
||
|
|
*/
|
||
|
|
|
||
|
|
#ifndef CONFIG_I2C
|
||
|
|
# error "CONFIG_I2C is required by MCP23X08"
|
||
|
|
#endif
|
||
|
|
|
||
|
|
#ifdef CONFIG_IOEXPANDER_INT_ENABLE
|
||
|
|
# ifndef CONFIG_MCP23X08_INT_NCALLBACKS
|
||
|
|
# define CONFIG_MCP23X08_INT_NCALLBACKS 4
|
||
|
|
# endif
|
||
|
|
#endif
|
||
|
|
|
||
|
|
#ifdef CONFIG_IOEXPANDER_INT_ENABLE
|
||
|
|
# ifndef CONFIG_SCHED_WORKQUEUE
|
||
|
|
# error Work queue support required. CONFIG_SCHED_WORKQUEUE must be selected.
|
||
|
|
# endif
|
||
|
|
#endif
|
||
|
|
|
||
|
|
#ifndef CONFIG_MCP23X08_INT_POLLDELAY
|
||
|
|
# define CONFIG_MCP23X08_INT_POLLDELAY 500000
|
||
|
|
#endif
|
||
|
|
|
||
|
|
/* MCP23X08 Definitions *****************************************************/
|
||
|
|
|
||
|
|
/* I2C frequency */
|
||
|
|
|
||
|
|
#define MCP23X08_I2C_MAXFREQUENCY 400000 /* 400KHz */
|
||
|
|
|
||
|
|
/* MCP23X08 *****************************************************************/
|
||
|
|
|
||
|
|
/* If IOCON.BANK = 0 Addressing Mode */
|
||
|
|
|
||
|
|
#define MCP23X08_IODIR 0x00
|
||
|
|
#define MCP23X08_IPOL 0x01
|
||
|
|
#define MCP23X08_GPINTEN 0x02
|
||
|
|
#define MCP23X08_DEFVAL 0x03
|
||
|
|
#define MCP23X08_INTCON 0x04
|
||
|
|
#define MCP23X08_IOCON 0x05
|
||
|
|
#define MCP23X08_GPPU 0x06
|
||
|
|
#define MCP23X08_INTF 0x07
|
||
|
|
#define MCP23X08_INTCAP 0x08
|
||
|
|
#define MCP23X08_GPIO 0x09
|
||
|
|
#define MCP23X08_OLAT 0x0a
|
||
|
|
|
||
|
|
#define MCP23X08_IOCON_INTPOL (1 << 1) /* Polarity of INT output pin */
|
||
|
|
#define MCP23X08_IOCON_ODR (1 << 2) /* Config INT pin as open-drain */
|
||
|
|
#define MCP23X08_IOCON_HAEN (1 << 3) /* HW Address enable bit */
|
||
|
|
#define MCP23X08_IOCON_DISSLW (1 << 4) /* Disable Slew Rate for SDA output */
|
||
|
|
#define MCP23X08_IOCON_SEQOP (1 << 5) /* Disable Sequential Operation */
|
||
|
|
|
||
|
|
#define MCP23X08_NR_GPIO_MAX 8
|
||
|
|
|
||
|
|
#define MCP23X08_POLLDELAY (CONFIG_MCP23X08_INT_POLLDELAY / USEC_PER_TICK)
|
||
|
|
|
||
|
|
/****************************************************************************
|
||
|
|
* Public Types
|
||
|
|
****************************************************************************/
|
||
|
|
|
||
|
|
#ifdef CONFIG_IOEXPANDER_INT_ENABLE
|
||
|
|
/* This type represents on registered pin interrupt callback */
|
||
|
|
|
||
|
|
struct mcp23x08_callback_s
|
||
|
|
{
|
||
|
|
ioe_pinset_t pinset; /* Set of pin interrupts that will generate
|
||
|
|
* the callback. */
|
||
|
|
ioe_callback_t cbfunc; /* The saved callback function pointer */
|
||
|
|
FAR void *cbarg; /* Callback argument */
|
||
|
|
};
|
||
|
|
#endif
|
||
|
|
|
||
|
|
/* This structure represents the state of the MCP23X08 driver */
|
||
|
|
|
||
|
|
struct mcp23x08_dev_s
|
||
|
|
{
|
||
|
|
struct ioexpander_dev_s dev; /* Nested structure to allow casting
|
||
|
|
* as public gpio expander.
|
||
|
|
*/
|
||
|
|
#ifdef CONFIG_MCP23X08_MULTIPLE
|
||
|
|
FAR struct mcp23x08_dev_s *flink; /* Supports a singly linked list of drivers */
|
||
|
|
#endif
|
||
|
|
|
||
|
|
FAR struct mcp23x08_config_s *config; /* Board configuration data */
|
||
|
|
FAR struct i2c_master_s *i2c; /* Saved I2C driver instance */
|
||
|
|
mutex_t lock; /* Mutual exclusion */
|
||
|
|
|
||
|
|
#ifdef CONFIG_IOEXPANDER_INT_ENABLE
|
||
|
|
#ifdef CONFIG_MCP23X08_INT_POLL
|
||
|
|
struct wdog_s wdog; /* Timer used to poll for missed interrupts */
|
||
|
|
#endif
|
||
|
|
|
||
|
|
ioe_pinset_t input; /* Last input registers */
|
||
|
|
ioe_pinset_t intstat; /* Pending interrupts */
|
||
|
|
struct work_s work; /* Supports the interrupt handling "bottom half" */
|
||
|
|
|
||
|
|
/* Saved callback information for each I/O expander client */
|
||
|
|
|
||
|
|
struct mcp23x08_callback_s cb[CONFIG_MCP23X08_INT_NCALLBACKS];
|
||
|
|
#endif
|
||
|
|
};
|
||
|
|
|
||
|
|
#endif /* CONFIG_IOEXPANDER && CONFIG_IOEXPANDER_MCP23X08 */
|
||
|
|
#endif /* __DRIVERS_IOEXPANDER_MCP23X08_H */
|