Reverts all previosly changed cAVS pipelines from 3 to 2 periods.
Now we have separate buffers for DMA, so there is no need to make
DAI buffers consist of 3 periods. DMA will take care of any internal
hardware requirements.
Signed-off-by: Tomasz Lauda <tomasz.lauda@linux.intel.com>
Switches all pipelines for cAVS platforms to timer scheduling.
This way we limit the number of interrupt levels processed
in the system. Timer, IPC and IDC are already on level 2 and
DMAs are on level 5.
Signed-off-by: Tomasz Lauda <tomasz.lauda@linux.intel.com>
Changes number of SSP, DMIC and ALH DAI periods from 2 to 3.
This way we can support both timer and new single DMA
channel scheduling.
Signed-off-by: Tomasz Lauda <tomasz.lauda@linux.intel.com>
Enable setting pcm min and max rate from top level m4 pipeline macro.
This way it is possible to configure the whole pipeline to correct
samplerate range in 1 file. Previously you needed to modify the pipeline
macros where the rate was hardcoded. As the frame count is calculated
from pcm/dai rate and scheduling time the frame count is obsolete.
Introduce pipeline rate parameter to help configuring components with
fixed output rate. We can't deduce this from pcm range since for example
src might accept bigger max rate than the following dai. Even though the
parameter is named "pipeline rate" it essentially means the "final"
output rate to which this pipeline is connected to (dai or other
pipeline). In capture pipelines it means the originating fixed dai rate.
Signed-off-by: Jaska Uimonen <jaska.uimonen@intel.com>
Add volume component, change to use 16KHz sample rate, and modify the
PCM ID from 5 to 8, as it is in lower priority comparing with pipelines
like amplifier.
Signed-off-by: Keyon Jie <yang.jie@linux.intel.com>
This patch adds to all DMIC related topologies the new token
SOF_TKN_INTEL_DMIC_UNMUTE_RAMP_TIME_MS. The value is set to 400
to correspond to 400 milliseconds long unmute ramp time. The
topology defined unmute will override the firmware internal
hard coded value if it is set in topology.
Signed-off-by: Seppo Ingalsuo <seppo.ingalsuo@linux.intel.com>
The only difference between them is the SSP index and name.
Use a macro during compilation to indicate which platform
we're building for and set these appropriately.
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
The CML board has the rt5682 connected to SSP0 and the
machine driver defines the dai link for the headset
with the name "SSP0-codec" too. So change the topology
file accordingly.
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
add the topology file for Cometlake with codec rt5682, a
analog codec with SSP1, and DMIC, HDMIs
Signed-off-by: Zhu Yingjiang <yingjiang.zhu@linux.intel.com>
Tomasz Lauda