spi: spi-geni-qcom: Don't try to set CS if an xfer is pending

If we get a timeout sending then this happens:

spi_transfer_one_message()
 ->transfer_one() AKA spi_geni_transfer_one()
  setup_fifo_xfer()
   mas->cur_xfer = non-NULL
 spi_transfer_wait() => TIMES OUT
 if (msg->status != -EINPROGRESS)
  goto out
 if (ret != 0 ...)
  spi_set_cs()
   ->set_cs AKA spi_geni_set_cs()
    # mas->cur_xfer is non-NULL

The above happens _before_ the SPI core calls ->handle_err() AKA
handle_fifo_timeout().

Unfortunately that won't work so well on geni.  If we got a timeout
transferring then it's likely that our interrupt handler is blocked,
but we need that same interrupt handler to run and the command channel
to be unblocked in order to adjust the chip select.  Trying to set the
chip select doesn't crash us but ends up confusing our state machine
and leads to messages like: Premature done. rx_rem = 32 bpw8

Let's just drop the chip select request in this case.  We can detect
the case because cur_xfer is non-NULL--it would have been set to NULL
in the interrupt handler if the previous transfer had finished.  Sure,
we might leave the chip select in the wrong state but it's likely it
was going to fail anyway and this avoids getting the driver even more
confused about what it's doing.

The SPI core in general assumes that setting chip select is a simple
operation that doesn't fail.  Yet another reason to just reconfigure
the chip select line as GPIOs.

Signed-off-by: Douglas Anderson <dianders@chromium.org>
Reviewed-by: Stephen Boyd <swboyd@chromium.org>
Link: https://lore.kernel.org/r/20201217142842.v3.3.I07afdedcc49655c5d26880f8df9170aac5792378@changeid
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-geni-qcom.c

@@ -207,9 +207,14 @@ static void spi_geni_set_cs(struct spi_device *slv, bool set_flag)
 		goto exit;
 	}
 
-	mas->cs_flag = set_flag;
-
 	spin_lock_irq(&mas->lock);
+	if (mas->cur_xfer) {
+		dev_err(mas->dev, "Can't set CS when prev xfer running\n");
+		spin_unlock_irq(&mas->lock);
+		goto exit;
+	}
+
+	mas->cs_flag = set_flag;
 	reinit_completion(&mas->cs_done);
 	if (set_flag)
 		geni_se_setup_m_cmd(se, SPI_CS_ASSERT, 0);