acrn-hypervisor/doc/user-guides/hv-parameters.rst

.. _hv-parameters:

ACRN Hypervisor Parameters
##########################

Generic hypervisor parameters
*****************************

The ACRN hypervisor supports the following parameter:

+-----------------+-----------------------------+----------------------------------------------------------------------------------------+
|   Parameter     |     Value                   |            Description                                                                 |
+=================+=============================+========================================================================================+
|                 | disabled                    | This disables the serial port completely.                                              |
|                 +-----------------------------+----------------------------------------------------------------------------------------+
| ``uart=``       | bdf@<BDF value>             | This sets the PCI serial port based on its BDF. e.g. ``bdf@0:18.1``                    |
|                 +-----------------------------+----------------------------------------------------------------------------------------+
|                 | port@<port address>         | This sets the serial port address.                                                     |
+-----------------+-----------------------------+----------------------------------------------------------------------------------------+

The Generic hypervisor parameters are specified in the GRUB multiboot/multiboot2 command.
For example:

.. code-block:: none
   :emphasize-lines: 5

   menuentry 'Boot ACRN hypervisor from multiboot' {
      insmod part_gpt
      insmod ext2
      echo 'Loading ACRN hypervisor ...'
      multiboot --quirk-modules-after-kernel /boot/acrn.32.out uart=bdf@0:18.1
      module /boot/bzImage Linux_bzImage
      module /boot/bzImage2 Linux_bzImage2
   }